Browsing Gujarati translation

11.

<userinput>b162</userinput> followed by &enterkey; to boot an MVME162

12.

<userinput>b167</userinput> followed by &enterkey; to boot an MVME166/167

13.

Macintosh Booting

14.

Go to the directory containing the installation files and start up the <command>Penguin</command> booter, holding down the <keycap>command</keycap> key. Go to the <userinput>Settings</userinput> dialogue (<keycombo> <keycap>command</keycap> <keycap>T</keycap> </keycombo>), and locate the kernel options line which should look like <userinput>root=/dev/ram ramdisk_size=15000</userinput> or similar.

15.

You need to change the entry to <userinput>root=/dev/<replaceable>yyyy</replaceable></userinput>. Replace the <replaceable>yyyy</replaceable> with the Linux name of the partition onto which you installed the system (e.g. <filename>/dev/sda1</filename>); you wrote this down earlier. For users with tiny screens, adding <userinput>fbcon=font:VGA8x8</userinput> (or <userinput>video=font:VGA8x8</userinput> on pre-2.6 kernels) may help readability. You can change this at any time.

16.

If you don't want to start GNU/Linux immediately each time you start, uncheck the <userinput>Auto Boot</userinput> option. Save your settings in the <filename>Prefs</filename> file using the <userinput>Save Settings As Default</userinput> option.

17.

Now select <userinput>Boot Now</userinput> (<keycombo> <keycap>command</keycap> <keycap>B</keycap> </keycombo>) to start your freshly installed GNU/Linux instead of the RAMdisk installer system.

18.

Debian should boot, and you should see the same messages as when you first booted the installation system, followed by some new messages.

19.

OldWorld PowerMacs

20.

If the machine fails to boot after completing the installation, and stops with a <prompt>boot:</prompt> prompt, try typing <userinput>Linux</userinput> followed by &enterkey;. (The default boot configuration in <filename>quik.conf</filename> is labeled Linux). The labels defined in <filename>quik.conf</filename> will be displayed if you press the <keycap>Tab</keycap> key at the <prompt>boot:</prompt> prompt. You can also try booting back into the installer, and editing the <filename>/target/etc/quik.conf</filename> placed there by the <guimenuitem>Install Quik on a Hard Disk</guimenuitem> step. Clues for dealing with <command>quik</command> are available at <ulink url="&url-powerpc-quik-faq;"></ulink>.