Browsing Hindi translation

1.

The application %1 is inhibiting suspension for the following reason:
%2

26.

The profile "%1" has been selected, but it does not exist!
Please check your PowerDevil configuration.

38.

PowerDevil was compiled without Xss and Xext support, or the XSync extension is not available. Determining idle time will not be possible. Please consider recompiling PowerDevil with at least one of these two libraries.

39.

No scaling methods were found. If your CPU is reasonably recent, this is probably because you have not loaded some kernel modules. Usually scaling modules have names similar to cpufreq_ondemand. Scaling is useful and can save a lot of battery. Click on "Attempt Loading Modules" to let PowerDevil try to load the required modules. If you are sure your PC does not support scaling, you can also disable this warning by clicking "Do not display this warning again".

42.

PowerDevil was compiled without Xext support, or the XSync extension is not available. XSync grants extra efficiency and performance, saving your battery and CPU. It is advised to use PowerDevil with XSync enabled.

43.

XSync does not seem your preferred query backend, though it is available on your system. Using it largely improves performance and efficiency, and it is strongly advised. Click on the button below to enable it now.

46.

No kernel modules for CPU scaling were found. Either you do not have them installed, or PowerDevil could not detect them.

70.

From this module, you can configure the Daemon, create and edit powersaving profiles, and see your system's capabilities.

72.

<h1>PowerDevil configuration</h1> <p>This module lets you configure PowerDevil. PowerDevil is a daemon (so it runs in background) that is started upon KDE startup.</p> <p>PowerDevil has 2 levels of configuration: a general one, that is always applied, and a profile-based one, that lets you configure a specific behavior in every situation. You can also have a look at your system capabilities in the last tab. To get you started, first configure the options in the first 2 tabs. Then switch to the fourth one, and create/edit your profiles. Last but not least, assign your profiles in the third Tab. You do not have to restart PowerDevil, just click "Apply", and you are done.</p>

73.

Another power manager has been detected. PowerDevil will not start if other power managers are active. If you want to use PowerDevil as your primary power manager, please remove the existing one and restart PowerDevil service.