Browsing Pennsylvania German translation

Don't show this notice anymore
Before translating, be sure to go through Ubuntu Translators instructions.
8186 of 86 results
81.
To access rescue mode, type <userinput>rescue</userinput> at the <prompt>boot:</prompt> prompt, or boot with the <userinput>rescue/enable=true</userinput> boot parameter. You'll be shown the first few screens of the installer, with a note in the corner of the display to indicate that this is rescue mode, not a full installation. Don't worry, your system is not about to be overwritten! Rescue mode simply takes advantage of the hardware detection facilities available in the installer to ensure that your disks, network devices, and so on are available to you while repairing your system.
Tag: para
(no translation yet)
Located in post-install.xml:687
82.
Instead of the partitioning tool, you should now be presented with a list of the partitions on your system, and asked to select one of them. Normally, you should select the partition containing the root file system that you need to repair. You may select partitions on RAID and LVM devices as well as those created directly on disks.
Tag: para
(no translation yet)
Located in post-install.xml:702
83.
If possible, the installer will now present you with a shell prompt in the file system you selected, which you can use to perform any necessary repairs. <phrase arch="x86"> For example, if you need to reinstall the GRUB boot loader into the master boot record of the first hard disk, you could enter the command <userinput>grub-install '(hd0)'</userinput> to do so. </phrase>
Tag: para
(no translation yet)
Located in post-install.xml:710
84.
If the installer cannot run a usable shell in the root file system you selected, perhaps because the file system is corrupt, then it will issue a warning and offer to give you a shell in the installer environment instead. You may not have as many tools available in this environment, but they will often be enough to repair your system anyway. The root file system you selected will be mounted on the <filename>/target</filename> directory.
Tag: para
(no translation yet)
Located in post-install.xml:722
85.
In either case, after you exit the shell, the system will reboot.
Tag: para
(no translation yet)
Located in post-install.xml:731
86.
Finally, note that repairing broken systems can be difficult, and this manual does not attempt to go into all the things that might have gone wrong or how to fix them. If you have problems, consult an expert.
Tag: para
(no translation yet)
Located in post-install.xml:735
8186 of 86 results

This translation is managed by translation group ubuntu-translators.

You are not logged in. Please log in to work on translations.

No-one has contributed to this translation yet.