Browsing Malay translation

268.

If you have more than two layouts and turn this option on, switching with the keyboard shortcut or clicking on the kxkb indicator will only cycle through the last few layouts. You can specify the number of layouts to rotate below. You can still access all layouts by right-clicking on the kxkb indicator.

269.

Number of layouts to rotate:

273.

Here you can set xkb extension options instead of, or in addition to, specifying them in the X11 configuration file.

275.

NumLock on KDE Startup

276.

If supported, this option allows you to setup the state of NumLock after KDE startup.<p>You can configure NumLock to be turned on or off, or configure KDE not to set NumLock state.

277.

Turn o&ff

282.

If supported, this option allows you to set the delay after which a pressed key will start generating keycodes. The 'Repeat rate' option controls the frequency of these keycodes.

285.

If supported, this option allows you to set the rate at which keycodes are generated while a key is pressed.

288.

If you check this option, pressing and holding down a key emits the same character over and over again. For example, pressing and holding down the Tab key will have the same effect as that of pressing that key several times in succession: Tab characters continue to be emitted until you release the key.

290.

If supported, this option allows you to hear audible clicks from your computer's speakers when you press the keys on your keyboard. This might be useful if your keyboard does not have mechanical keys, or if the sound that the keys make is very soft.<p>You can change the loudness of the key click feedback by dragging the slider button or by clicking the up/down arrows on the spin box. Setting the volume to 0% turns off the key click.