Browsing Spanish translation

Don't show this notice anymore
Before translating, be sure to go through Ubuntu Translators instructions and Spanish guidelines.
110 of 268 results
11.
write (adds) the scancodes to the device scancode/keycode table from an specified file
(no translation yet)
Located in utils/keytable/keytable.c:252
17.
Set a parameter for the protocol decoder
(no translation yet)
Located in utils/keytable/keytable.c:268
19.
Sets the delay before repeating a keystroke
(no translation yet)
Located in utils/keytable/keytable.c:269
20.
PERIOD
PERIOD
Translated by J. on 2017-09-10
Reviewed by Jose Luis Tirado on 2017-10-13
Located in utils/keytable/keytable.c:270
23.
Auto-load a table, based on a configuration file. Only works with sysdev.
(no translation yet)
Located in utils/keytable/keytable.c:258
37.
Invalid value `%s'
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
(no translation yet)
Located in utils/keytable/keytable.c:533
41.
Failed to parse toml: %s
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
(no translation yet)
Located in utils/keytable/keytable.c:592
43.
No protocols found
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
(no translation yet)
Located in utils/keytable/keytable.c:615
48.
Invalid period: %s
(no translation yet)
Located in utils/keytable/keytable.c:547
51.
Failed to read config file %s
(no translation yet)
Located in utils/keytable/keytable.c:573
110 of 268 results

This translation is managed by Ubuntu Spanish Translators, assigned by Ubuntu Translators.

You are not logged in. Please log in to work on translations.

Contributors to this translation: Augusto Salinas, David Resendiz, Fco. Javier Serrador, J., Jose Luis Tirado, Paco Molinero.