Browsing Polish translation

185.

Value is equal to (100-temp. Celsius), allowing manufacturer to set a minimum threshold which corresponds to a maximum temperature.

187.

Count of times the heads are loaded off the media. Heads can be unloaded without actually powering off.

192.

Count of 'unstable' sectors (waiting to be remapped, because of unrecoverable read errors). If an unstable sector is subsequently read successfully, the sector is remapped and this value is decreased. Read errors on a sector will not remap the sector immediately (since the correct value cannot be read and so the value to remap is not known, and also it might become readable later); instead, the drive firmware remembers that the sector needs to be remapped, and will remap it the next time it's written. However some drives will not immediately remap such sectors when written; instead the drive will first attempt to write to the problem sector and if the write operation is successful then the sector will be marked good (in this case, the 'Reallocation Event Count' (0xC4) will not be increased). This is a serious shortcoming, for if such a drive contains marginal sectors that consistently fail only after some time has passed following a successful write operation, then the drive will never remap these problem sectors.

195.

The count of errors in data transfer via the interface cable as determined by ICRC (Interface Cyclic Redundancy Check).

198.

Count of off-track errors.

199.

Count of Data Address Mark errors (or vendor-specific).

205.

Count of buzz routines needed to spin up the drive due to insufficient power.

211.

Distance the disk has shifted relative to the spindle (usually due to shock or temperature). Unit of measure is unknown.

212.

Time spent operating under data load (movement of magnetic head armature).

214.

Resistance caused by friction in mechanical parts while operating.