Translations by youss44

youss44 has submitted the following strings to this translation. Contributions are visually coded: currently used translations, unreviewed suggestions, rejected suggestions.

110 of 10 results
1.
Could not access drive %1. The drive is still busy. Wait until it is inactive and then try again.
2008-09-29
لم استطع الوصول إلى القرص %1. القرص ما زال مشغولاً انتظر حتى يتوقف عن العمل ثم حاول مرة أخرى.
2.
Could not write to file %1. The disk in drive %2 is probably full.
2008-09-29
لم استطع الكتابة إلى الملف %1. من المحتمل أن يكون القرص في الجهاز %2 ممتلئ.
3.
Could not access %1. There is probably no disk in the drive %2
2008-09-29
لم استطع الوصول إلى %1. من المحتمل أن لا يوجد قرص في الجهاز %2
4.
Could not access %1. There is probably no disk in the drive %2 or you do not have enough permissions to access the drive.
2008-09-29
لم استطع الوصول إلى %1. من المحتمل أن لا يوجد قرص في الجهاز %2 أو ليس لديك الأذون الكافية للوصول إلى الجهاز.
5.
Could not access %1. The drive %2 is not supported.
2008-09-29
لم استطع الوصول إلى %1. الجهاز %2 غير مدعوم.
6.
Could not access %1. Make sure the floppy in drive %2 is a DOS-formatted floppy disk and that the permissions of the device file (e.g. /dev/fd0) are set correctly (e.g. rwxrwxrwx).
2008-09-29
لم استطع الوصول إلى %1. تأكد من أن القرص المرن الموجود في الجهاز %2 قد تمً تهيئته على نمط DOS و أن الأذون لملف هذا الجهاز (مثال /dev/fd0) معين بشكل صحيح (مثال rwxrwxrwx).
7.
Could not access %1. The disk in drive %2 is probably not a DOS-formatted floppy disk.
2008-09-29
لم استطع الوصول إلى %1. القرص المرن في الجهاز %2 ربما لم تتم تهيئته على نمط DOS.
8.
Access denied. Could not write to %1. The disk in drive %2 is probably write-protected.
2008-09-29
الوصول مرفوض. لم استطع الكتابة إلى %1. القرص في الجهاز %2 ربما يكون محمي ضد الكتابة.
9.
Could not read boot sector for %1. There is probably not any disk in drive %2.
2008-09-29
لم استطع قراءة قطاع الإقلاع لـ %1. ربما لا يوجد أي قرص في الجهاز %2.
10.
Could not start program "%1". Ensure that the mtools package is installed correctly on your system.
2008-09-29
لم استطع بدء تشغيل البرنامج "%1". تأكد من أن حزمة mtools مثبتة بطريقة صحيحة في نظامك.