Translations by Mai Hao Hui

Mai Hao Hui has submitted the following strings to this translation. Contributions are visually coded: currently used translations, unreviewed suggestions, rejected suggestions.

110 of 10 results
1.
Could not access drive %1. The drive is still busy. Wait until it is inactive and then try again.
2008-10-05
无法访问驱动器 %1。 驱动器仍然是忙的。 请等待它停止工作,然后重试。
2.
Could not write to file %1. The disk in drive %2 is probably full.
2008-10-05
无法写入文件 %1。 驱动器 %2 内的磁盘可能已满。
3.
Could not access %1. There is probably no disk in the drive %2
2008-10-05
无法访问 %1。 驱动器 %2 内可能没有磁盘
4.
Could not access %1. There is probably no disk in the drive %2 or you do not have enough permissions to access the drive.
2008-10-05
无法访问 %1。 驱动器 %2 内可能没有磁盘,或您没有访问驱动器的权限。
5.
Could not access %1. The drive %2 is not supported.
2008-10-05
无法访问 %1。 不支持驱动器 %2。
6.
Could not access %1. Make sure the floppy in drive %2 is a DOS-formatted floppy disk and that the permissions of the device file (e.g. /dev/fd0) are set correctly (e.g. rwxrwxrwx).
2008-10-05
无法访问 %1。 请确保在驱动器 %2 的软盘是已经格式化成DOS格式的 还有设备文件的权限设置(例如 /dev/fd0)是正确的(例如 rwxrwxrwx)。
7.
Could not access %1. The disk in drive %2 is probably not a DOS-formatted floppy disk.
2008-10-05
无法访问 %1。 驱动器 %2 内的磁盘可能不是DOS格式的。
8.
Access denied. Could not write to %1. The disk in drive %2 is probably write-protected.
2008-10-05
访问被禁止。 无法写入 %1。 驱动器 %2 内的磁盘可能是写保护的。
9.
Could not read boot sector for %1. There is probably not any disk in drive %2.
2008-10-05
无法读取 %1 的引导扇区。 驱动器 %2 内可能没有磁盘。
10.
Could not start program "%1". Ensure that the mtools package is installed correctly on your system.
2008-10-05
无法启动程序“%1”。 请确认软件包 mtools 已经在您的系统上正确安装。