Browsing Serbian Latn translation

Don't show this notice anymore
Before translating, be sure to go through Ubuntu Translators instructions.
110 of 10 results
1.
Could not access drive %1.
The drive is still busy.
Wait until it is inactive and then try again.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Nisam mogao da pristupim uređaju %1.
Uređaj je još uvek zauzet.
Sačekajte dok ne završi sa radom, pa onda pokušajte ponovo.
Translated and reviewed by Chusslove Illich on 2006-04-21
Located in kio_floppy.cpp:200
2.
Could not write to file %1.
The disk in drive %2 is probably full.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Nisam mogao da pišem u fajl %1.
Disketa u uređaju %2 je verovatno puna.
Translated and reviewed by Chusslove Illich on 2006-04-21
Located in kio_floppy.cpp:204 kio_floppy.cpp:1144
3.
Could not access %1.
There is probably no disk in the drive %2
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Nisam mogao da pristupim %1.
Verovatno nema diskete u uređaju %2
Translated and reviewed by Chusslove Illich on 2006-04-21
Located in kio_floppy.cpp:214
4.
Could not access %1.
There is probably no disk in the drive %2 or you do not have enough permissions to access the drive.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Nisam mogao da pristupim %1.
Disketa verovatno nije ubačena u uređaj %2 ili nemate pravo pristupa uređaju.
Translated and reviewed by Chusslove Illich on 2006-04-21
Located in kio_floppy.cpp:218
5.
Could not access %1.
The drive %2 is not supported.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Nisam mogao da pristupim %1.
Uređaj %2 nije podržan.
Translated and reviewed by Chusslove Illich on 2006-04-21
Located in kio_floppy.cpp:222
6.
Could not access %1.
Make sure the floppy in drive %2 is a DOS-formatted floppy disk
and that the permissions of the device file (e.g. /dev/fd0) are set correctly (e.g. rwxrwxrwx).
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
There are leading/trailing spaces here. Each one represents a space character. Enter a space in the equivalent position in the translation.
Nisam mogao da pristupim %1.
Proverite da li je disketa u uređaju %2 formatirana za DOS
i da li su dozvole pristupa uređajskom fajlu (npr. /dev/fd0) ispravno podešene (npr. rwxrwxrwx).
Translated and reviewed by Chusslove Illich on 2006-04-21
Located in kio_floppy.cpp:227
7.
Could not access %1.
The disk in drive %2 is probably not a DOS-formatted floppy disk.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Nisam mogao da pristupim %1.
Disketa u uređaju %2 verovatno nije formatirana za DOS.
Translated and reviewed by Chusslove Illich on 2006-04-21
Located in kio_floppy.cpp:231
8.
Access denied.
Could not write to %1.
The disk in drive %2 is probably write-protected.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Pristup je odbijen.
Nisam mogao da pišem u %1.
Disketa u uređaju %2 je verovatno zaštićena od upisa.
Translated and reviewed by Chusslove Illich on 2006-04-21
Located in kio_floppy.cpp:235
9.
Could not read boot sector for %1.
There is probably not any disk in drive %2.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Nisam mogao da pročitam but sektor za %1.
Verovatno nema diskete u uređaju %2.
Translated and reviewed by Chusslove Illich on 2006-04-21
Located in kio_floppy.cpp:244
10.
Could not start program "%1".
Ensure that the mtools package is installed correctly on your system.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Nisam mogao da pokrenem program „%1“.
Proverite da li je paket mtools ispravno instaliran na vašem sistemu.
Translated and reviewed by Chusslove Illich on 2006-04-21
Located in kio_floppy.cpp:368
110 of 10 results

This translation is managed by translation group ubuntu-translators.

You are not logged in. Please log in to work on translations.

Contributors to this translation: Chusslove Illich.