Browsing Croatian translation

Don't show this notice anymore
Before translating, be sure to go through Ubuntu Translators instructions and Croatian guidelines.
110 of 10 results
1.
Could not access drive %1.
The drive is still busy.
Wait until it is inactive and then try again.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Pristupanje uređaju %1 nije moguće.
Uređaj je još zauzet.
Pričekajte dok se zaustavi i onda pokušajte ponovno.
Translated and reviewed by Renato Pavičić on 2007-03-09
Located in kio_floppy.cpp:200
2.
Could not write to file %1.
The disk in drive %2 is probably full.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Zapisivanje u datoteku %1 nije moguće.
Disk u uređaju %2 vjerojatno je ispunjen.
Translated and reviewed by Renato Pavičić on 2007-03-09
Located in kio_floppy.cpp:204 kio_floppy.cpp:1144
3.
Could not access %1.
There is probably no disk in the drive %2
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Pristupanje uređaju %1 nije moguće.
U uređaju %2 vjerojatno nema diska.
Translated and reviewed by Renato Pavičić on 2007-03-09
Located in kio_floppy.cpp:214
4.
Could not access %1.
There is probably no disk in the drive %2 or you do not have enough permissions to access the drive.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Pristupanje uređaju %1 nije moguće.
U uređaju %2 vjerojatno nema diska ili nemate dopuštenja za pristup uređaju.
Translated and reviewed by Renato Pavičić on 2007-03-09
Located in kio_floppy.cpp:218
5.
Could not access %1.
The drive %2 is not supported.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Pristupanje uređaju %1 nije moguće.
Uređaj %2 nije podržan.
Translated and reviewed by Renato Pavičić on 2007-03-09
Located in kio_floppy.cpp:222
6.
Could not access %1.
Make sure the floppy in drive %2 is a DOS-formatted floppy disk
and that the permissions of the device file (e.g. /dev/fd0) are set correctly (e.g. rwxrwxrwx).
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
There are leading/trailing spaces here. Each one represents a space character. Enter a space in the equivalent position in the translation.
Pristupanje uređaju %1 nije moguće.
Provjerite je li disketa u uređaju %2 oblikovana u DOS obliku i jesu li dopuštenja
pristupa uređaju (npr. /dev/fd0) ispravno postavljena (npr. rwxrwxrwx).
Translated and reviewed by Renato Pavičić on 2007-03-09
Located in kio_floppy.cpp:227
7.
Could not access %1.
The disk in drive %2 is probably not a DOS-formatted floppy disk.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Pristupanje uređaju %1 nije moguće.
Disk u uređaju %2 vjerojatno nije oblikovana u DOS obliku.
Translated and reviewed by Renato Pavičić on 2007-03-09
Located in kio_floppy.cpp:231
8.
Access denied.
Could not write to %1.
The disk in drive %2 is probably write-protected.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Pristup je odbijen.
Zapisivanje na uređaj %1 nije moguće.
Disk u uređaju %2 vjerojatno je zaštićena od zapisivanja.
Translated and reviewed by Renato Pavičić on 2007-03-09
Located in kio_floppy.cpp:235
9.
Could not read boot sector for %1.
There is probably not any disk in drive %2.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Čitanje pokretačkog sektora u uređaju %1 nije moguće.
U uređaju %2 vjerojatno nema diska.
Translated and reviewed by Renato Pavičić on 2007-03-09
Located in kio_floppy.cpp:244
10.
Could not start program "%1".
Ensure that the mtools package is installed correctly on your system.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Pokretanje programa "%1" nije moguće.
Provjerite je li paket 'mtools' pravilno instaliran na vašem sustavu.
Translated and reviewed by Renato Pavičić on 2007-03-09
Located in kio_floppy.cpp:368
110 of 10 results

This translation is managed by Ubuntu Croatian Translators, assigned by Ubuntu Translators.

You are not logged in. Please log in to work on translations.

Contributors to this translation: Renato Pavičić.