Browsing Swedish translation

Don't show this notice anymore
Before translating, be sure to go through Ubuntu Translators instructions and Swedish guidelines.
110 of 10 results
1.
Could not access drive %1.
The drive is still busy.
Wait until it is inactive and then try again.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Kunde inte komma åt enheten %1.
Enheten är fortfarande upptagen.
Vänta tills den har slutat arbeta och försök sedan igen.
Translated and reviewed by Stefan Asserhäll on 2006-04-21
Located in kio_floppy.cpp:200
2.
Could not write to file %1.
The disk in drive %2 is probably full.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Kunde inte skriva till filen %1.
Disketten i enhet %2 är antagligen full.
Translated and reviewed by Stefan Asserhäll on 2006-04-21
Located in kio_floppy.cpp:204 kio_floppy.cpp:1144
3.
Could not access %1.
There is probably no disk in the drive %2
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Kunde inte komma åt %1.
Det finns antagligen ingen diskett i enhet %2.
Translated and reviewed by Stefan Asserhäll on 2006-04-21
Located in kio_floppy.cpp:214
4.
Could not access %1.
There is probably no disk in the drive %2 or you do not have enough permissions to access the drive.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Kunde inte komma åt %1.
Det finns antagligen ingen diskett i enheten %2, eller så har du inte tillräckliga behörigheter för att komma åt enheten.
Translated and reviewed by Stefan Asserhäll on 2006-04-21
Located in kio_floppy.cpp:218
5.
Could not access %1.
The drive %2 is not supported.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Kunde inte komma åt %1.
Enhet %2 stöds inte.
Translated and reviewed by Stefan Asserhäll on 2006-04-21
Located in kio_floppy.cpp:222
6.
Could not access %1.
Make sure the floppy in drive %2 is a DOS-formatted floppy disk
and that the permissions of the device file (e.g. /dev/fd0) are set correctly (e.g. rwxrwxrwx).
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
There are leading/trailing spaces here. Each one represents a space character. Enter a space in the equivalent position in the translation.
Kunde inte komma åt %1.
Kontrollera att disketten i enhet %2 är DOS-formaterad
samt att skyddet på enhetsfilen (t ex /dev/fd0) är korrekt inställt (t ex rwxrwxrwx).
Translated and reviewed by Stefan Asserhäll on 2006-04-21
Located in kio_floppy.cpp:227
7.
Could not access %1.
The disk in drive %2 is probably not a DOS-formatted floppy disk.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Kunde inte komma åt %1.
Disketten i enhet %2 är antagligen inte DOS-formaterad.
Translated and reviewed by Stefan Asserhäll on 2006-04-21
Located in kio_floppy.cpp:231
8.
Access denied.
Could not write to %1.
The disk in drive %2 is probably write-protected.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Åtkomst nekades.
Kunde inte skriva till %1.
Disketten i enhet %2 är antagligen skrivskyddad.
Translated and reviewed by Stefan Asserhäll on 2006-04-21
Located in kio_floppy.cpp:235
9.
Could not read boot sector for %1.
There is probably not any disk in drive %2.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Kunde inte läsa startsektorn för %1.
Det finns antagligen ingen diskett i enhet %2.
Translated and reviewed by Stefan Asserhäll on 2006-04-21
Located in kio_floppy.cpp:244
10.
Could not start program "%1".
Ensure that the mtools package is installed correctly on your system.
There are line breaks here. Each one represents a line break. Start a new line in the equivalent position in the translation.
Kunde inte starta programmet "%1".
Kontrollera att mtools-paketet är korrekt installerat på systemet.
Translated and reviewed by Stefan Asserhäll on 2006-04-21
Located in kio_floppy.cpp:368
110 of 10 results

This translation is managed by Ubuntu Swedish Translators, assigned by Ubuntu Translators.

You are not logged in. Please log in to work on translations.

Contributors to this translation: Stefan Asserhäll.