Translations by Zlatko Popov

Zlatko Popov has submitted the following strings to this translation. Contributions are visually coded: currently used translations, unreviewed suggestions, rejected suggestions.

110 of 10 results
1.
Could not access drive %1. The drive is still busy. Wait until it is inactive and then try again.
2007-10-26
Няма достъп до устройство %1. То е заето. Изчакайте да свърши операцията и опитайте отново.
2.
Could not write to file %1. The disk in drive %2 is probably full.
2007-10-26
Неуспешен запис на файл %1. Вероятно дискетата в %2 е пълна.
3.
Could not access %1. There is probably no disk in the drive %2
2007-10-26
Няма достъп до %1. Вероятно няма диск в устройство %2.
4.
Could not access %1. There is probably no disk in the drive %2 or you do not have enough permissions to access the drive.
2007-10-26
Няма достъп до %1. Вероятно няма дискета в устройство %2 или нямате достатъчно права за достъп.
5.
Could not access %1. The drive %2 is not supported.
2007-10-26
Няма достъп до %1. Устройство %2 не се поддържа.
6.
Could not access %1. Make sure the floppy in drive %2 is a DOS-formatted floppy disk and that the permissions of the device file (e.g. /dev/fd0) are set correctly (e.g. rwxrwxrwx).
2007-10-26
Няма достъп до %1. Проверете дали в устройство %2 има DOS-форматирана дискета и дали правата за достъп са зададени правилно (напр. rwxrwxrwx).
7.
Could not access %1. The disk in drive %2 is probably not a DOS-formatted floppy disk.
2007-10-26
Няма достъп до %1. Вероятно дискетата в %2 не е DOS-форматирана.
8.
Access denied. Could not write to %1. The disk in drive %2 is probably write-protected.
2007-10-26
Отказан достъп. Записът на %1 беше неуспешен. Вероятно дискетата в %2 е защитена от запис.
9.
Could not read boot sector for %1. There is probably not any disk in drive %2.
2007-10-26
Секторът на самозареждане за %1 не може да бъде прочетен. Вероятно няма диск в устройство %2.
10.
Could not start program "%1". Ensure that the mtools package is installed correctly on your system.
2007-10-26
Програмата "%1" не може да бъде стартирана. Проверете дали пакета "mtools" е инсталиран правилно.