Browsing Esperanto translation

2.

<p>If this option is checked K3b will perform all writing steps with the laser turned off.<p>This is useful, for example, to test a higher writing speed or whether your system is able to write on-the-fly.<p><b>Caution:</b> DVD+R(W) does not support simulated writing.

4.

Disk at once

5.

<p>If this option is checked, K3b will write the CD in 'disk at once' mode as compared to 'track at once' (TAO).<p>It is always recommended to use DAO where possible.<p><b>Caution:</b> Track pregaps with a length other than 2 seconds are only supported in DAO mode.

6.

Write in disk at once mode

7.

Use Burnfree

8.

Enable Burnfree (or Just Link) to avoid buffer underruns

9.

<p>If this option is checked, K3b enables <em>Burnfree</em> (or <em>Just Link</em>). This is a feature of the CD writer which avoids buffer underruns.<p>Without <em>burnfree</em>, if the writer cannot get any more data a buffer underrun would occurs, since the writer needs a constant stream of data to write the CD.<p>With <em>burnfree</em> the writer can <em>mark</em> the current position of the laser and get back to it when the buffer is filled again;but, since this means having little data gaps on the CD, <b>it is highly recommended to always choose an appropriate writing speed to prevent the usage of burnfree, especially for audio CDs</b> (in the worst case one would hear the gap).<p><em>Burnfree</em> was formally known as <em>Burnproof</em> but since it has become part of the MMC standard it was renamed.

10.

Only create image

11.

<p>If this option is checked, K3b will only create an image and not do any actual writing.<p>The image can later be written to a CD/DVD with most current writing programs (including K3b of course).

13.

Remove image