Browsing Amharic translation

15.

PURPOSE:
DisplayPort audio interface verification
STEPS:
1. Plug an external DisplayPort device with sound (Use only one HDMI/DisplayPort interface at a time for this test)
2. Click the Test button
VERIFICATION:
Did you hear the sound from the DisplayPort device?

16.

PURPOSE:
This test will check that headphones connector works correctly
STEPS:
1. Connect a pair of headphones to your audio device
2. Click the Test button to play a sound to your audio device
VERIFICATION:
Did you hear a sound through the headphones and did the sound play without any distortion, clicks or other strange noises from your headphones?

17.

PURPOSE:
This test will check that recording sound using the onboard microphone works correctly
STEPS:
1. Disconnect any external microphones that you have plugged in
2. Click "Test", then speak into your internal microphone
3. After a few seconds, your speech will be played back to you.
VERIFICATION:
Did you hear your speech played back?

18.

PURPOSE:
This test will check that recording sound using an external microphone works correctly
STEPS:
1. Connect a microphone to your microphone port
2. Click "Test", then speak into the external microphone
3. After a few seconds, your speech will be played back to you
VERIFICATION:
Did you hear your speech played back?

19.

PURPOSE:
This test will check that a USB audio device works correctly
STEPS:
1. Connect a USB audio device to your system
2. Click "Test", then speak into the microphone
3. After a few seconds, your speech will be played back to you
VERIFICATION:
Did you hear your speech played back through the USB headphones?

20.

Play back a sound on the default output and listen for it on the default input.

24.

This test will verify that the volume levels are at an acceptable level on your local system. The test will validate that the volume is greater than or equal to minvol and less than or equal to maxvol for all sources (inputs) and sinks (outputs) recognized by PulseAudio. It will also validate that the active source and sink are not muted. You should not manually adjust the volume or mute before running this test.

30.

Run gtkperf to make sure that GTK based test cases work

31.

Run Render-Bench XRender/Imlib2 benchmark

32.

Run Qgears2 XRender Extension gearsfancy benchmark