Browsing Spanish translation

Don't show this notice anymore
Before translating, be sure to go through Launchpad Translators instructions and Spanish guidelines.
2029 of 172 results
ATL Statements
(no translation yet)
Located in ../../source/atl.rst:120
The following are the ATL statements.
(no translation yet)
Located in ../../source/atl.rst:122
Interpolation Statement
(no translation yet)
Located in ../../source/atl.rst:125
The interpolation statement is the main way that ATL controls transformations.
(no translation yet)
Located in ../../source/atl.rst:127
The first part of the interpolation statement is used to select a function that time-warps the interpolation. (That is, a function from linear time to non-linear time.) This can either be done by giving the name of a warper registered with ATL, or by giving the keyword "warp" followed by an expression giving a function. Either case is followed by a number, giving the number of seconds the interpolation should take.
(no translation yet)
Located in ../../source/atl.rst:137
If no warp function is given, the interpolation is run for 0 seconds, using the pause function.
(no translation yet)
Located in ../../source/atl.rst:144
The warper and duration are used to compute a completion fraction. This is done by dividing the time taken by the interpolation by the duration of the interpolation. This is clamped to the duration, and then passed to the warper. The result returned by the warper is the completion fraction.
(no translation yet)
Located in ../../source/atl.rst:147
The interpolation statement can then contain a number of other clauses. When a property and value are present, then the value is the value the property will obtain at the end of the statement. The value can be obtained in several ways:
(no translation yet)
Located in ../../source/atl.rst:152
If the value is followed by one or two knots, then spline motion is used. The starting point is the value of the property at the start of the interpolation, the end point is the property value, and the knots are used to control the spline.
(no translation yet)
Located in ../../source/atl.rst:156
If the interpolation statement contains a "clockwise" or "counterclockwise" clause, circular motion is used, as described below.
(no translation yet)
Located in ../../source/atl.rst:161
2029 of 172 results

This translation is managed by Launchpad Spanish Translators, assigned by Launchpad Translators.

You are not logged in. Please log in to work on translations.

No-one has contributed to this translation yet.